You may find that you have small values left on your accounts. This may be due to rounding, discrepancies, or you owe a supplier so little that they have written the value off. In such cases, you can use the Write Off Small Amounts option.
Up to 50,000 records can be displayed at once, and you can write off up to 1000 purchase values, on a supplier account. You can write off purchase values, even if the associated transaction is part allocated. If you need to write off more than 1000 values, select the option again and make a further selection of values to write off.
The default transaction value to write off is 200 (base currency), however this amount can be changed.
The appropriate debit or credit note is generated automatically for each write off. The transactions are posted to the supplier account and the Nominal Ledger accounts to update the balances.
When writing off values on a foreign currency supplier account, the exchange rate applied to the original transaction is used to convert the value to base currency.
A report is produced for you to check.
If the write off is an invoice |
If the write off is a credit note |
---|---|
|
|
|
|
|
|
|
|
|
|
|
|
Note: The central VAT file is not updated.
You must have:
Open: Purchase Ledger > Adjust Transactions > Write Off Small Amounts.
Accept the default nominal account to be used to write off the tax (VAT) element of the entry, or select the relevant nominal account from the drop-down list.
If the system is set up to use cost centre breakdown, only the nominal account reference number needs to be specified. The necessary cost centre and department codes are attached automatically from the account header record.
If the system is not set up to use cost centre breakdown, the full nominal account, including cost centre and department codes must be specified.
If your nominal accounts are set up as follows (the first three accounts listed below are set up in default nominal accounts, and the fourth is set up on the supplier account record): |
||||||
Default bad debt write off |
68100 |
(profit and loss) |
||||
Default tax input |
15100 |
ADM |
ADM |
(balance sheet) |
||
Creditors control |
25100 |
ADM |
ADM |
(balance sheet) |
||
Default nominal account |
44100 |
FAC |
STD |
|||
and you write off a small value transaction for the following values (using a standard VAT rate set to 17.5%): |
||||||
Net |
10.00 |
|
||||
Tax |
1.75 |
|
||||
Gross |
11.75 |
|
||||
the nominal posting results will be: |
||||||
If cost centre breakdown is not selected |
||||||
Bad debt write off |
Cr |
10.00 |
68100 |
FAC |
STD |
|
Default tax input |
Cr |
15100 |
ADM |
ADM |
||
Creditors control |
Dr |
11.75 |
25100 |
ADM |
ADM |
|
If cost centre breakdown is selected |
||||||
Bad debt write off |
Cr |
10.00 |
68100 |
FAC |
STD |
|
Default tax input |
Cr |
1.75 |
15100 |
FAC |
STD |
|
Creditor control |
Dr |
11.75 |
25100 |
FAC |
STD |
|
Note: The nominal accounts specified must exist in the Nominal Ledger to prevent postings to the suspense account. |
Cost centre breakdown is activated by selecting the Accounting System Manager setting Split postings between cost centres for balance sheet accounts on the Operational settings tab.
Accept or amend the maximum value to write off.
Qualifying transactions are displayed for you to select from. If the number of these is too large to be processed efficiently, you are prompted to reduce the maximum value to write off.